Install axle KR/K2 (Figure 202 ... 205)
Squeeze in rectangular rings (1) and engage them.
Install O-Ring (2).
NOTE ;
Grease rectangular rings and align them centrically !
Heat housing bore (about 90° C).
( S ) Hot-air blower 220 V 5870 221 500
( S ) Hot-air blower 110 V 5870 221 501
Thread up axle (compl.) until contact is obtained.
Fasten axle by means of hex. nuts.
Torque limit (M8/ 8) 23 Nm
Transmission and Torque Converter SPC000007
Page 143
To Next Page
Loading...
