Relax the output shaft bearing by tapping and check
the free movement of the spur gear.
Heat housing bore.
( S ) Hot-air blower 220 V 5870 221 500
( S ) Hot-air blower 110 V 5870 221 501
( S ) Pre-heating sleeve 5870 801 003
Wet oil supply flange in the area of suction ports
and pressure ports with Loctite (Type- No. 221).
Install two adjusting screws. Install flat gasket
(Arrow) and thread up oil supply flange until contact
is obtained.
( S ) Adjusting screws (M8) 5870 204 011
ATTENTION ;
For different Transmission Versions, one O-Ring
must be installed instead of the flat gasket !
Installation position of the O-Ring see Arrow/ Figure
257 !
Transmission and Torque Converter SPC000007
Page 157
To Next Page
Loading...
