Insert cover plate in the gear case.
Position the two cover plates and fasten them by
means of hex. head screws (install flat washers).
Torque limit (M8/8.8) 23 Nm
NOTE:
Secure hex. head screws with Loctite (Type-No.
241) !
Tilt gear case 180°.
Insert roller bearing until contact is obtained.
NOTE :
Pay attention to the installation position, open cage
side of roller bearing is showing outwards (on top)!
Insert sleeve (Arrow) flush-mounted in the hollow
shaft.
SPC000007 Transmission and Torque Converter
Page 206
To Next Page
Loading...
