Install the two closing covers.
NOTE:
Wet sealing surfaces with Loctite (Type-No.270)!
( S ) Driver 5870 057 015
( S ) Handle 5870 260 002
Fasten closing covers by means of hex. Head
screws and mount screw plug (Arrow).
NOTE:
In tall new flat gasket as well as O-Ring !
Torque limit
(Hex. head screws M8/8.8) 23 Nm
Torque limit
(Screw plug M22x1.5) 60 Nm
Assemble flat gasket and fasten speedometer
(compl.) by means of hex. head screws on the gear
case.
Torque limit (M8/8.8) 23 Nm
SPC000007 Transmission and Torque Converter
Page 210
To Next Page
Loading...
