Heat output flange and press it against shoulder
until contact is obtained.
Fix output flange by means of disk and hex. head
screws.
Torque limit (M8/8.8) 23 Nm
NOTE :
Wet contact surface of disk as well as of the screw
heads with sealing compound !
Insert hex. head screws with Loctite (Type-No. 241) !
( S ) Clamping yoke 5870 240 025
Install two adjusting screws and replace flat gasket.
Grease rectangular ring (Figure 35), align it
centrically and introduce the complete clutch until
contact is obtained.
( S ) Adjusting screws (M8) 5870 204 011
Fasten clutch by means of hex. head screws.
Torque limit (M8/8.8) 23 Nm
Transmission and Torque Converter SPC000007
Page 221
To Next Page
Loading...
