Dräger Fabius plus - Selecting and Setting; Monitoring Settings and System Settings; Changing the Ventilation Mode

Instructions for use Fabius plus SW 3.n 45
Operating concept
D Volume monitoring
Display of:
– Respiratory rate of the patient in breaths
per minute (Freq)
– Tidal volume (VT)
– Minute volume (MV)
– Upper and lower alarm limits of the minute
volume
E Airway pressure monitoring
Display of:
– Positive end-expiratory pressure (PEEP)
– Mean airway pressure (MEAN)
– Plateau pressure (PLAT)
– Peak pressure (PEAK)
F Pressure waveform for airway pressure
G Softkeys (labeling depending on ventilation
mode)
Selecting and setting
Monitoring settings and system settings
Each of these settings requires a selection and
confirmation by pressing the rotary knob.
– To change a value or parameter or to navigate
in the menus, turn the rotary knob.
In this document, these procedural steps are
simply called "select."
– To confirm a value or a selection, press the
rotary knob.
Without confirmation with the rotary knob the value
or parameter is not changed. In this document,
these procedural steps are simply called "confirm."
Changing the ventilation mode
1 Select a ventilation mode (A).
– The LED in the key flashes.
– The pressure waveform is replaced by a
dialog window with ventilation settings.
– A message with further instructions (B) is
displayed.
2 Confirm the ventilation mode.
– The LED in the key is continuously lit up.
– The pressure waveform is displayed again.
25359
A
B