Dräger Fabius plus - Connecting the compact breathing system

Assembly and preparation
66 Instructions for use Fabius plus SW 3.n
Connecting the compact breathing
system
1 Completely pull out the locking pin (A) and hold
it in that position.
2 Insert the assembled compact breathing
system in the provided holder (B).
3 Release the locking pin again and turn the
compact breathing system until the locking pin
engages.
4 Connect the fresh-gas hose (C) to the
corresponding connection of the compact
breathing system.
5 Connect the ventilator hose to the
corresponding connector (D) on the anesthesia
workstation.
6 Connect the other end of the ventilator hose to
the ventilator connector (E) of the compact
breathing system.
If Fabius has a screw connection, the sealing rings
of this screw connection must be undamaged and
clean.
Only hand-tighten the screw connection. Do not
use tools.
2094225428
A
B
C
20943
D
E