Dräger Polytron 8000 Series User Manual

Paidalanu | kk
Paidalanu jönındegı nūsqaulyq | Dräger Polytron
®
8000 Series BJ nūsqasy ≥ 4.0.x 21
Polytron 8200, Polytron 8310
55850
◄
Back to
measure
Information Instrument
Warnings
Sensor
Faults
Calibration Data logger
Device codes
Modules
Settings
Last cal. date
Zero calibration
Next cal. date
Span calibration
Alarm on/off
Auto calibration
Logger status Relay A1
Graph Relay A2
SIL activation
Alarm A1
Instrument
Alarm & Relays Alarm A2
Communication
Passwords Fault warmup
Sensor
Date and time Set alarm A1
Data logger
Language Set alarm A2
Function key Set fault
Device init
Data logr on/off
SW dongle Calibration PWD
Data logger
Bumptest Settings PWD
Clear datalogr
Display
Display contrast
Display mode
Sample Time
Displaytest
Peak/Average
Trigger on/off
Polling address
Trigger value
Unique identifier
Stack/Roll
Tag
HART interface Dräger REGARD
Analog interface
Modbus Fault current
Profibus address Warning
Warning interval
Auto calibration Warning current
Sensor type Maint. signal
Gas settings Maint. current
Reset sensor
Beamblock on/off
1)
Calibration interval
Beamblock value
1)
Fast response
Beamblock limit
1)
Display capture Analog offset
DSIR Category Analog psan
DD Sensor Latching Set current
Set concentr.
Set fault
Set warning
Set mainten.
Set beamblock
1)
1) Parameter not used by Dräger Polytron 8200/Polytron 8310.
Modbus address
Modbus baudrate
Modbus parity

Dräger Polytron 8000 Series Specifications

General

Ingress Protection	IP66/67
Detection Principle	Electrochemical, Infrared, Catalytic Bead
Gases Detected	Combustible gases, toxic gases, and oxygen
Display	LCD with backlight
Humidity Range	0 to 99% RH (non-condensing)
Housing Material	Stainless steel
Output Signal	4-20 mA, HART, RS-485 Modbus
Power Supply	10 to 30 V DC
Certifications	ATEX, IECEx, CSA
Temperature Range	-40 °C to +65 °C (depending on sensor)