Dräger Polytron 8000 Series User Manual

20 Paidalanu jönındegı nūsqaulyq | Dräger Polytron
®
8000 Series BJ nūsqasy ≥ 4.0.x
kk | Paidalanu
7.5.5 Mäzırge şolu
Polytron 8100
55846
◄
Back to
measure
Information Instrument
Warnings
Sensor
Faults Alarm on/off
Calibration Data logger
Device codes Relay A1
Modules Relay A2
Settings
Alarm A1
Last cal. date Alarm A2
Next cal. date Fault warmup
Vitality Set alarm A1
Zero calibration
Sensor temperature Set alarm 2
Span calibration
SensorAlive Set fault
Auto calibration
Logger status
Graph Calibration PWD
SIL activation
Settigns PWD
Instrument
Alarm & Relays
Communication
Passwords
Sensor
Date and time Display contrast
Data logger
Language Display mode
Function key Displaytest
Device init
Datalogr. on/off
SW dongle
Data logger
Bumptest Polling address
Clear datalogr
Display Unique identifier
Tag
Sample time
Dräger REGARD
Peak/Average
Trigger on/off
Trigger value
Fault current
Stack/Roll
HART interface Warning
Analog interface Warning interval
Modbus Warning current
Profibus address Maint. signal
Maint. current
Change sensor
Beamblock on/off
1)
Auto calibration
Beamblock value
1)
Sensortest
Beamblock limit
1)
Sensor lock DSA warn current
Gas settings DSA warn limit
Basic channel initialization Analog offset
Calibration interval Analog span
Set Sensortest Set current
Display capture Set concentr.
Set fault
Set warning
Set mainten.
Set beamblock
1)
Set DSA warning
1) Parameter not used by Dräger Polytron 8100.
Modbus address
Modbus baudrate
Modbus parity

Dräger Polytron 8000 Series Specifications

General

Ingress Protection	IP66/67
Detection Principle	Electrochemical, Infrared, Catalytic Bead
Gases Detected	Combustible gases, toxic gases, and oxygen
Display	LCD with backlight
Humidity Range	0 to 99% RH (non-condensing)
Housing Material	Stainless steel
Output Signal	4-20 mA, HART, RS-485 Modbus
Power Supply	10 to 30 V DC
Certifications	ATEX, IECEx, CSA
Temperature Range	-40 °C to +65 °C (depending on sensor)