Dräger Polytron 8000 Series User Manual

操作 | ja
取扱説明書 | Dräger Polytron
®
8000 Series SW バージ ョ ン ≥4.0.x 67
Polytron 8700、 Polytron 8720
55849
◄
Back to
measure
Information Instrument
Warnings
Sensor
Faults
Calibration Data logger
Device codes
Modules
Settings
Lat cal. date
Zero calibration
Next cal. date
Span calibration
Alarm on/off
Auto calibration
Logger status Relay A1
Graph Relay A2
SIL activation
Alarm A1
Instrument
Alarm & Relays Alarm A2
Communication
Passwords Fault warmup
Sensor
Date and time Set alarm 1
Data logger
Language Set alarm 2
Function key Set fault
Device init
Datalogr. on/off
SW dongle Calibration PWD
Data logger
Bumptest Settings PWD
Clear datalogr
Display
Display contrast
Display mode
Sample Time
Displaytest
Peak/Average
Trigger on/off
Polling address
Trigger value
Unique identifier
Stack/Roll
Tag
HART interface Dräger REGARD
Analog interface
Modbus Fault current
Profibus address Warning
Warning interval
Auto calibration Warning current
Sensor lock Maint. signal
Sensor type Maint. current
Gas settings Beamblock on/off
Basic channel initialization Beamblock value
Calibration interval Beamblock limit
Fast response Analog offset
Display capture Analog span
Set current
Set concentr.
Set fault
Set warning
Set mainten.
Set beamblock
UGLD signal
Modbus address
Modbus baudrate
Modbus parity

Dräger Polytron 8000 Series Specifications

General

Ingress Protection	IP66/67
Detection Principle	Electrochemical, Infrared, Catalytic Bead
Gases Detected	Combustible gases, toxic gases, and oxygen
Display	LCD with backlight
Humidity Range	0 to 99% RH (non-condensing)
Housing Material	Stainless steel
Output Signal	4-20 mA, HART, RS-485 Modbus
Power Supply	10 to 30 V DC
Certifications	ATEX, IECEx, CSA
Temperature Range	-40 °C to +65 °C (depending on sensor)