Note
If the DTC is set to "OFF", the DPL function can
not be activated.
If the DTC is set to OFF and you press button (12), the
instrument panel shows for 5 seconds the indication
DTC OFF – DPL NOT AVAILABLE; when the 5
seconds are over, the instrument panel goes back to
the main screen.
Note
If the instrument panel detects a control unit
error when entering the DPL menu, regardless of the
currently set display mode, it will show the blinking
message LAUNCH CONTROL ERROR for three
seconds and then again the main screen.
DTC off
DPL not available
Exit
Fig. 159
Fig. 160
200
To Next Page
Loading...
