Dynapac CC722 User Manual

Maintenance - 2000h
4812158801_E.pdf 2018-04-03
Pump drive - Changing the oil
Fig. Pump gear
1. Filler plug/dipstick
2. Drain plug
1
2
When the pump drive has reached working
temperature: Position the roller on a level surface.
Switch off the engine, activate the parking brake
and disconnect the power.
Switch off the engine, activate the parking brake
and disconnect the power.
Collect the oil in a container and dispose of for
environmentally correct handling.
Collect the oil in a container and dispose of for
environmentally correct handling.
Wipe around the plugs.
Unscrew the filler plug/dipstick (1) and the drain plug
(2). Drain the oil, approx. 4 liters.
Clean and refit the drain plug.
Fill with new transmission oil according to the lubricant
specification. Fill slowly so that the oil has time to level
out.
Check with the dipstick and do not overfill. Tighten the
filler plug/dipstick and wipe up any spilled oil.
92

Dynapac CC722 Specifications

General

Brand	Dynapac
Model	CC722
Category	Construction Equipment
Language	English