Maintenance, 10h
4812158801_E.pdf 2018-04-03
Coolant level - Check
Fig. Water tank
1. Max. level
2. Min. level
3. Filler cap
1
2
3
Check that level of the coolant is between the max.
and min. marks.
Take great caution if the radiator cap must be
opened while the engine is hot. Wear protective
gloves and goggles.
Take great caution if the radiator cap must be
opened while the engine is hot. Wear protective
gloves and goggles.
Fill with a mixture of 50% water and 50% anti freeze.
See the lubrication specification in these instructions
and in the engine manual.
Flush the system every other year and change
the coolant. Make sure also that the air flow
through the cooler is unobstructed.
Flush the system every other year and change
the coolant. Make sure also that the air flow
through the cooler is unobstructed.
Water separator - Drainage
Fig. The fuel filter's water separator
1. Drainage tap
1
Place a receptacle below the drainage tap located at
the bottom of the fuel filter. Open the tap and collect
the water and contaminants in the receptacle. Allow it
to run until pure fuel comes out. Close the drainage
tap.
Deliver the collected fluid to environmentally
correct handling.
Deliver the collected fluid to environmentally
correct handling.
70
To Next Page
Loading...
