EasyManuals Logo

Dynapac CC722 User Manual

Dynapac CC722
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #95 background imageLoading...
Page #95 background image
Maintenance - 1000h
4812158801_E.pdf2018-04-03
Fuel tank - Drainage
1
Fig. Fuel tank
1. Drain plug
Water and sediment in the fuel tank are removed via
the drain plug (1) in the bottom of the fuel tank.
Be very careful during draining. Do not drop the
plug or else all the fuel will flow out.
Be very careful during draining. Do not drop the
plug or else all the fuel will flow out.
Drainage must be performed when the roller has been
stationary for an extended period, e.g. after being
stationary overnight. The fuel level should be as low
as possible.
The roller should preferably have been standing with
this side slightly lower, so that water and sediment
have gathered near the drain plug (1).
Collect the condensate and sediment in a
container and deliver to environmentally correct
handling.
Collect the condensate and sediment in a
container and deliver to environmentally correct
handling.
Drain as
follows:
- Place a container under the plug (1).
- Remove the plug (1).
- Drain out the condensate and sediment until only
pure fuel emerges at the plug.
- Refit the plug again.
87

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynapac CC722 and is the answer not in the manual?

Dynapac CC722 Specifications

General IconGeneral
BrandDynapac
ModelCC722
CategoryConstruction Equipment
LanguageEnglish

Related product manuals