Model 200i and 250i Motorcycle Dynamometer Installation Guide
CHAPTER 3
High Pressure Blower
3-38
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
HIGH PRESSURE BLOWER
The high pressure blower supplies air to cool the bike’s engine. This section will walk
you through the blower installation procedures.
To prevent possible injury, open the CPI door and set the main breaker to the
off position and unplug the dyno. Refer to Figure 3-1 for breaker location.
PARTS LIST
The following table lists all of the parts included in the High Pressure Blower
Installation kit (P/N 76722003). Check your kit against the parts listed to make sure
you have received all of the parts. If any part is missing, contact Dynojet Technical
Support.
part number description quantity
61328101 High Pressure Blower 2
63413004 Lower Blower Arm Assembly (longer pin) 2
63413001 Upper Blower Arm Assembly (longer arm) 2
26215521 Washer, 1.87 x 1.25 ID x .25 THK (Poly Washer) 2
35712992 Clamp Lever, 3/8-16 x 1.5” 2
To Next Page
Loading...
