Model 200i and 250i Motorcycle Dynamometer Installation Guide
CHAPTER 3
Air Pump and Filter Assembly
3-22
PARTS LIST
The following table lists all of the parts included in the Air Pump and Filter Assembly
(P/N 64193009 Domestic or P/N 64193010 European) Installation kit. Check your kit
against the parts listed to make sure you have received all of the parts. If any part is
missing, contact Dynojet Technical Support.
INSTALLING THE FILTER AND PUMP ASSEMBLIES
1 Remove the cover from the right side of the dyno. Refer to “Remove and Replace
Dyno and Drum Covers” on page 3-3.
2 Remove the four 1/4-inch screws securing the air fuel ratio (AFR) blanking plate to
the dyno and remove the plate. Set the screws aside, they will be used later.
3 Remove the lower two 3/8-inch bolts, washers, and nuts from the lower right
corner of the rear of the dyno and set aside to be used later.
Figure 3-24: Remove the Blanking Plate
part number description quantity
21125500 Filter and Sensor Housing 1
21626204 Pump Bracket 1
21696204 Pump Bottle Bracket 1
31991331 1/2” Diameter Rubber Hose 2
34420001 Filter Assembly 1
34491000 Filter Kit Replacement 5
39460210 Drip Bottle, Clear, Plastic 2
43310600 Grommet, 7/16” ID x 3/4” OD 2
64193050
or
64193051
Pump Assembly Replacement, 120V
or
Pump Assembly Replacement, 240V
1
lower bolts,
washers, and nuts
blanking plate
To Next Page
Loading...
