Model 200i and 250i Motorcycle Dynamometer Installation Guide
APPENDIXE
Extended Tire Carriage—Discontinued
E-6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EXTENDED TIRE CARRIAGE—DISCONTINUED
If your tire carriage does not have the bearing bracket, you will need to use the
following directions. Refer to page 3-29 for instructions on removing the standard tire
carriage.
INSTALLING THE EXTENDED TIRE CARRIAGE SUPPORT BRACKET
1 Loosely attach the extended carriage support bracket to the front of the dyno
using six 3/8-16 x 1/2-inch button-head flange allen bolts.
2 Using a straight edge, line the top of the support bracket with the top of the dyno
chassis.
3 Tighten all six screws.
Figure E-6: Install the Extended Carriage Support Bracket
extended carriage
support bracket
To Next Page
Loading...
