STANDARD AND EXTENDED TIRE CARRIAGE INSTALLATION—DISCONTINUED
Extended Tire Carriage—Discontinued
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
E-7
4 Secure the extended carriage strap to the dyno using two 5/16 x 1-inch bolts and
two 5/16-inch lock washers.
5 Using the holes on the strap as a guide, drill two 3/8-inch holes in the extended
carriage support bracket.
Note: If your support bracket already has the required holes, skip this step.
Figure E-7: Secure Strap to Dyno and Drill Holes
6 Secure the strap to the support bracket using two 5/16 x 1-inch bolts,
two 5/16-inch lock washer, two 5/16-inch flat washers, and two 5/16-inch nuts.
Figure E-8: Secure Strap to Support Bracket
lock washer
bolt
strap
support
bracket
drill holes
strap
lock washer
bolt
strap
support
bracket
nut
flat washer
To Next Page
Loading...
