STANDARD AND EXTENDED TIRE CARRIAGE INSTALLATION—DISCONTINUED
Extended Tire Carriage—Discontinued
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
E-9
INSTALLING THE EXTENDED TIRE CARRIAGE
1 Slide the extended carriage under the nut block and clamps until the carriage
screw contacts the nut block. Be sure the slide plate is under the rear carriage
clamps.
2 Slide the hand crank onto the end of the carriage screw.
3 Secure the hand crank to the screw shaft by tightening the set screw using a
5/32-inch allen wrench.
4 Using the hand crank, screw the carriage through the nut block.
Figure E-10: Install the Extended Carriage
hand crank
extended carriage
To Next Page
Loading...
