APPENDIX C
EEC Finger Guards Installation
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
C-2
EEC FINGER GUARDS INSTALLATION
The EEC finger guards are secured to the drum module hood and provide extra
protection from the drum by regulating the distance between the drum and the
chassis. The placement of the finger guards can be manually adjusted.
You will need the following parts:
REMOVING THE DRUM MODULE HOOD
Before installing the EEC finger guards, the drum module hood must be removed.
Never operate the dynamometer with the drum module hood removed.
Dynojet recommends using a T30 Torx driver (Snap-On PFTx30E) to
remove the 1/4-inch screws. For dynos with serial numbers lower than
2030152, Dynojet recommends using a hardened 5/32-inch hex driver
(such as Snap-On FA5E). A standard allen key may round off in the
shallow screw head.
part description part description
drum guard, CE, left and
right (2)
P/N 21229105
screw, 1/4-20 x 5/8", ph,
torx (4)
P/N 36561045
To Next Page
Loading...
Need help?
General
