INSTALLATION
Eddy Current Brake
Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
2-13
UNPACKING THE EDDY CURRENT BRAKE
1 Remove the sides of the crate.
2 Remove the four screws securing the top cover and set aside. Remove the cover
and set aside.
3 Remove the hardware box and theta controller from the crate and verify the
hardware box contents using the parts list.
For more information on mounting the theta controller refer to page 2-20.
#
RECORD
Be sure you record the eddy current brake number on the inside cover of this
manual.
Figure 2-12: Remove the Covers
top cover
eddy current brake number
To Next Page
Loading...
