C-1
Above Ground Model 250i Motorcycle Dynamometer Installation Guide
APPENDIX C
EEC K
IT
The European Economic Community (EEC) finger guards are a valuable safety device
that allow you to regulate the distance between the dyno chassis and the drum while
the door safety switch provides an added safety measure by automatically activating
the dyno’s air brake when it is triggered.
This appendix provides instructions for installing the EEC Kit to the model 200i/250i
motorcycle dyno. This appendix will walk you through installing the EEC finger
guards and door safety switch. To ensure safety and accuracy in the procedures,
perform the procedures as they are described.
This Appendix is divided into the following categories:
• EEC Finger Guards Installation, page C-2
• Door Safety Switch, page C-6
To Next Page
Loading...
Need help?
General
