Above Ground Model 250i Motorcycle Dynamometer Installation Guide
1-2
INTRODUCTION
Before installing your dyno, please take a moment to read this guide for installation
instructions, dyno features, and other important information.
This guide is designed to be a reference tool in your everyday work and includes the
following chapters and information:
SPECIFICATIONS AND OPERATING REQUIREMENTS
This chapter describes the requirements and specifications for the dyno.
DYNO INSTALLATION
This chapter describes the procedures for installing the dyno.
ACCESSORIES
This chapter lists each dyno accessory alphabetically and describes the procedures for
installing and using this accessory.
CONTROL PANEL INTERFACE OPERATION
This chapter describes the control panel interface (CPI) operating procedures.
BASIC DYNO OPERATION
This chapter describes basic dyno operating procedures and maintenance.
RED HEAD INSTALLATION
This appendix describes the procedures for installing the Red Head anchors.
POWER REQUIREMENTS AND INSTALLATION
This appendix describes power requirements and installation instructions.
EEC KIT
This appendix describes the procedures for installing the EEC finger guards and door
safety switch.
TORQUE VALUES
This appendix describes standard and metric torque values.
To Next Page
Loading...
Need help?
General
