Eaton EMR-3MP0 - Communication Protocols; General SCADA (Communication) Setting

3 Communication Protocols
3.1
General SCADA (Communication) Setting
The set of available SCADA protocols depends on the ordered hardware variant (see ╚═▷
“Catalog Codes for the EMR-3MP0”, ╚═▷ “Communication Protocol Codes”).
You have to de󰊎ne which one of the available SCADA protocols the EMR-3MP0 shall use.
This is done by setting [Device Planning] »Protocol« to the required communication
protocol.
After this, you have to make some more settings related to the selected protocol.
110 www.eaton.com EMR-3MP0
3 Communication Protocols
3.1 General SCADA (Communication) Setting