Eaton EMR-3MP0 - Communication Protocol Codes

2.2.4
Communication Protocol Codes
The following table lists the “Communication Options” letters from the Order Code (see
╚═▷ “Catalog Codes for the EMR-3MP0”), together with the respective communication
interfaces and protocols that are available with this order option.
# Interface Available Communication Protocols
A ― Without protocol
B RS485 / terminals
╚═▷ “RS485 - Modbus® RTU”
64 5321
Modbus RTU, DNP3.0 RTU
╚═▷ “Modbus®”
╚═▷ “DNP3”
C Ethernet 100 MB / RJ45
╚═▷ “Ethernet - RJ45”
Modbus TCP, DNP3.0 TCP/UDP
╚═▷ “Modbus®”
╚═▷ “DNP3”
D optic 󰅡ber / ST connector
╚═▷ “Pro󰊎bus DP/ Modbus® RTU via Fiber
Optic”
RxD TxD
Pro󰊎bus-DP
╚═▷ “Pro󰊎bus”
E RS485 / D-SUB
╚═▷ “Pro󰊎bus DP via D‑SUB”
Pro󰊎bus-DP
╚═▷ “Pro󰊎bus”
F optic 󰅡ber / ST connector
╚═▷ “Pro󰊎bus DP/ Modbus® RTU via Fiber
Optic”
RxD TxD
Modbus RTU, DNP3.0 RTU
╚═▷ “Modbus®”
╚═▷ “DNP3”
G RS485 / D-SUB
╚═▷ “Modbus® RTU via D‑SUB”
Modbus RTU, DNP3.0 RTU
╚═▷ “Modbus®”
╚═▷ “DNP3”
66 www.eaton.com EMR-3MP0
2 Hardware
2.2 EMR-3MP0 – Installation and Wiring