Eaton EMR-3MP0 - Page 182

◦ Settings can be made in menu branch [Protection Para / RTD / LB Group]
◦ Status values can be found in menu branch [Operation / Status Display / Temp-
Prot / RTD / LB Group]
◦ Measured temperature values can be found in menu branch [Operation /
Measured Values / URTD]
• The channels Aux1, Aux2 belong to the group “Auxiliary Temperature Inputs”:
◦
Settings can be made in menu branch [Protection Para / RTD / Aux Group]
◦
Status values can be found in menu branch [Operation / Status Display / Temp-
Prot / RTD / Aux Group]
◦ Measured temperature values can be found in menu branch [Operation /
Measured Values / URTD]
Within each group, always the hottest RTD is used. Only these groups are used, the
selective channels are not used.
182 www.eaton.com EMR-3MP0
4 Protective Elements
4.13 26/38/49 – RTD Protection Module