C-54 IM02601001E www.eaton.com
Modbus Register Maps
754E - 754E 30031 - 30031 Limit #1 Out Low Setpoint SINT16 -200.0 to +200.0 0.1% of full scale Setpoint for the "below"
limit (LM2), see notes
11-12.
1
754F - 754F 30032 - 30032 Limit #1 In Low Threshold SINT16 -200.0 to +200.0 0.1% of full scale Threshold at which
"below" limit clears;
normally greater than
or equal to the "below"
setpoint; see notes
11-12.
1
7550 - 7554 30033 - 30037 Limit #2 SINT16 Same as Limit #1. Same as Limit #1. Same as Limit #1. 5
7555 - 7559 30038 - 30042 Limit #3 SINT16 5
755A - 755E 30043 - 30047 Limit #4 SINT16 5
755F - 7563 30048 - 30052 Limit #5 SINT16 5
7564 - 7568 30053 - 30057 Limit #6 SINT16 5
7569 - 756D 30058 - 30062 Limit #7 SINT16 5
756E - 7572 30063 - 30067 Limit #8 SINT16 5
7573 - 7582 30068 - 30083 Reserved
Set to 0. 16
7583 - 75C2 30084 - 30147 Reserved
Set to 0. 64
75C3 - 75E5 30148 - 30182 Reserved
Set to 0. 35
75E6 - 75E6 30183 - 30183 Programmable Settings Update Counter UINT16 0-65535
Increments each time
programmable settings
are changed; occurs
when new checksum is
calculated.
1
75E7 - 7626 30184 - 30247 Reserved for Software Use
Set to 0. 64
Block Size: 248
Reserved Block write only in PS update
mode
7917
-
7B56 31000
-
31575 Reserved Set to 0. 576
Reserved Registers. Set to 0.
7B57 - 7B76 31576 - 31607 Reserved Set to 0. 32
Block Size: 608
Programmable Settings for Option Card 1
Option Card 1 Setups Block write only in PS update
mode
7CFF
-
7CFF 32000
-
32000 Class ID of the Option Card 1 Settings UINT16 bit-mapped -------- cccctttt Which class (cccc) and
type(tttt) of card the Op-
tion Settings for Card 1
apply to. See note 19.
1
7D00 - 7D3E 32001 - 32063 Settings for Option Card 1, First Overlay
-- see below
Register assignments depend on which type of card is in the slot. See overlays below. 63
7D3F - 7F3E 32064 - 32575 Settings for Option Card 1, Second Overlay
-- see below
Register assignments depend on which type of card is in the slot. See overlays below. 512
Block Size: 576
To Next Page
Loading...
