www.eaton.com IM02601001E C-63
Modbus Register Maps
812A - 812A 33067 - 33067 Source register for Output#1 UINT16 0 to 65535 This register should be
programmed with the
address of the register,
whose value is to be
used for current output.
In different words, the
current level output
of analog board will
change with the value
of the register pointed
here.
1
812B - 812C 33068 - 33069 High value of source register for output#1 Depends on the format parameter Value read from the
source register at which
High nominal current
will be output. Ex-
ample: for the 4-20mA
card, if this register is
programmed with 750,
then the current output
will be 20mA when the
value read from the
source register is 750.
2
812D - 812E 33070 - 33071 Low value of source register for output#1 Depends on the format parameter Value read from the
source register at which
Low nominal current
will be output. Ex-
ample: for the 4-20mA
card, if this register is
programmed with 0,
then the current output
will be 4mA when the
value read from the
source register is 0.
2
812F - 8134 33072 - 33077 Analog output#2 format, register, max &
min
Same as analog output #1. 6
8135 - 813A 33078 - 33083 Analog output#3 format, register, max &
min
Same as analog output #1. 6
813B - 8140 33084 - 33089 Analog output#4 format, register, max &
min
Same as analog output #1. 6
8141 - 8326 33090 - 33575 Reserved
Set to 0. 486
Block Size: 512
12-Bit Readings Section
12-Bit Block
read-only except as noted
9C40 - 9C40 40001 - 40001 System Sanity Indicator UINT16 0 or 1 none 0 indicates proper meter
operation.
1
9C41 - 9C41 40002 - 40002 Volts A-N UINT16 2047 to 4095 volts 2047= 0, 4095= +150 1
9C42 - 9C42 40003 - 40003 Volts B-N UINT16 2047 to 4095 volts
volts = 150 * (register -
2047) / 2047
1
9C43 - 9C43 40004 - 40004 Volts C-N UINT16 2047 to 4095 volts 1
9C44 - 9C44 40005 - 40005 Amps A UINT16 0 to 4095 amps 0= -10, 2047= 0, 4095=
+10
1
To Next Page
Loading...
