Eaton UltraShift PLUS Series User Manual

171
© 2017 Eaton. All rights reserved
2018.12.12
Main Case Main Shaft Assembly with Low Force Gearing | Service Procedures TRSM0940
Main Case Main Shaft Assembly with Low Force
Gearing
1. Place the Main Shaft vertical and hold the noise in a
vise or a pilot hole in a piece of wood.
2. Install
the first stepped washer. The stepped edge
should be facing down so that it contacts the 4th/5th
sliding clutch. Rotate the washer to lock it into place.

Eaton UltraShift PLUS Series Specifications

General

Brand	Eaton
Model	UltraShift PLUS Series
Category	Microphone system
Language	English