2018.12.12
© 2017 Eaton. All rights reserved
172
TRSM0940 Service Procedures | Main Case Main Shaft Assembly with Low Force Gearing
3. Locate the groove that has the roll pin, use a piece of
5/32” air line to push up through the key way groove to
lock the no-burn washers in place as the Main Shaft is
built.
4. Install the Overdrive
Gear or Direct Drive Gear
(depending on the model of the transmission) and the
no-burn washer. Rotate the washer and push the air
line through.
5. Install the
3rd Gear and stepped washer. Rotate the
no-burn washer and push the air line through.
6. Install
the 2nd/3rd Sliding Clutch. Make sure the wide
slot on the sliding clutch aligns with the keyway.
To Next Page
Loading...