2018.12.12
© 2017 Eaton. All rights reserved
180
TRSM0940 Service Procedures | Main Case Main Shaft without Low Force Gearing Disassembly
13. Remove 4th Gear (5th for direct drive) from the Main
Shaft.
14. Remove the last stepped washer from the Main Shaft.
Note: There are 2 ty
pes of washers on the Main Shaft,
stepped and no burn. The no burn washers are flat on
both sides, while the stepped washers on one side and
have a raised edge or step on the other. The stepped
washers should have the stepped side contacting the
sliding clutches and the flat side contacting the gear.
To Next Page
Loading...