EBS EBS-6100 - Linking File Names with Parameter-Block Names

EBS
Ink-Jet Systems
®
 EBS-6100 Printer User's Manual
 Paragraph 4 - Operating the Printe
r
20070529#20.5
 39
displayed with the TEXT EDITION and COPY & EDIT commands but they cannot be modified
with these commands.
The following functions are available while the text files library is viewed:
Terminal key
Function
¤£
To display the next/previous screen showing text file names.
An alphabetical or
numerical key
To display the text file names starting from the first name that begins with
a given character.
Y¢ (HOME)
lub
Y£
To place the cursor on the first name in the library.
Y¡ (END) lub
Y¤
To place the cursor on the last name in the library.
ª
To assign/remove the read only attribute to/from a selected text file. The
operation is available only when the service password is enabled. If the
password level is too low, you will be asked for a password when you
make an attempt to change the attribute.
¥
To assign the read only attribute to every text in the library. The option is
available only when the service password is enabled. If the password
level is too low, you will be asked for a password when you make an
attempt to change the attribute.
¦
To remove the read only attribute from every text in the library. The
option is available only when the service password is enabled. If the
password level is too low, you will be asked for a password when you
make an attempt to change the attribute.
¨
To detach the parameter block from the text file previously selected with
the cursor.
NOTE: If no text files are defined in the library, the command is ignored.
4.4.1.8. Linking File Names with Parameter-Block Names
Certain print parameters need to be set during printing (see section 4.4.3.5 Print
Parameters). When you change the text to be printed (e.g. as the line of products to be
labelled changes), the parameters need to be adjusted accordingly. Therefore it would be
advisable to have a tool that might enable you to do the following:
 Store print parameters for a given text file,
 Link the parameters stored with the text file to be printed,
 Set all parameters for the text file automatically just before the printing, after the print
command has been selected.
A solution to meet the above requirements is offered by EBS printers. Every text file (that is
stored in the library) can be linked with a parameter block and such a pair can be stored in the
file library. To do this, follow the procedure below:
In the main MENU select the TEXT SERVICE item and then the LINK PARAMETERS item.
The display shows the text file library from which you should select a text file name (see also
section 4.4.1.1 General Information on Text Files). Then the parameter block library is
displayed, from which you should select a parameter block name.
!