EBS EBS-6100 - Modifying Print Parameters; Vertical Direction; Initial Distance

EBS
Ink-Jet Systems
®
 EBS-6100 Printer User's Manual
 Paragraph 4 - Operating the Printe
r
20070529#20.5
 57
Modifying Print Parameters
The following keys help you to move along the parameter list or modify
settings:
 the ¤ and £ keys to move the cursor to parameter boxes,
 the Y¢ (HOME) or Y£ keys to position the cursor on the first
parameter setting,
 the Y¡ (END) or Y¤ keys to position the cursor on the last parameter
setting.
The setting of each of the parameters can be modified with the ¡ and ¢ keys. The
setting of a numerical parameter can also be input directly from the keypad and
confirmed with the V key.
A detailed description of the print parameters
(according to pattern shown in the table
below) is give further in this document.
1
Parameter name
displayed in the
parameter menu
2 Range of settings
3 Default setting
4
Can it be modified
during printing?
A description of the print parameter
Vertical Direction
1
Vert. direct.
2 UP,DOWN
3
UP
4 YES
The parameter defines two modes of printing in the vertical
direction: normal or "upside down". It is useful when the object
labelled is reversed.
PRINT HEAD
VERTICAL (UP) DIRECTION OF PRINTING
Fig. 4.4.3.5.1.
Initial Distance
1
Space
2
0,0 ; 0,1 ; ... ; 6553,5
mm
3 2,0 mm
4 YES
The parameter defines the distance given in millimetres, from
the point where the photo detector has been activated to the
point where printing of a text file should start. During printing
the distance is measured off properly provided that the settings
of the Cnv spd m/min parameter (for Generator=GEN) and
the Enc const p/m parameter (for Generator=SHAFT)
correspond to real measurements taken at the print place. It
enables a user to adjust the print position in relation to the edge
of the object to be labelled.