EBS EBS-6100 - Printing Operations

 EBS-6100 Printer User's Manual
 Paragraph 4 - Operating the Printer
EBS
Ink-Jet Systems
®
 54
20070529#20.5
Terminal key Function
¥
To assign the read only attribute to every block in the
library. The option is available only when the service
password is enabled. If the password level is too low, you
will be asked for a password when you make an attempt to
change the attribute.
¦
To remove the read only attribute from every block in the
library. The option is available only when the service
password is enabled. If the password level is too low, you
will be asked for a password when you make an attempt to
change the attribute.
NOTE:
If no parameter blocks are defined in the library, the command is ignored.
4.4.3. Printing
4.4.3.1. Stopping the Printing
The printing can be terminated in two parallel and independent ways:
• With the STOP PRINTING command on the terminal.
• With the PRINT ON/OFF key on the main pad of the external panel (when the key
is pressed, the STOP PRINTING) command is executed). The key can be used
no matter where the cursor position is within the control menu (for example, you
can stop the printing while editing a text file).
To stop the printing follow the procedure below.
In the main MENU select the PRINTING item and then the STOP PRINTING item,
or
Press the PRINT ON/OFF key on the external panel.
If the command is selected while the printer is in the print mode, the current print job
finishes and no other label is printed. The execution of the command results in the
application of high voltage. The green PRINT ON/OFF lamp on the main pad of the
external panel and the red HV ON lamp on the internal panel go out. The printer
switches to the stop mode.
If the printing is to be interrupted immediately (the current print job is not to be
completed), use the QUICK STOP command.
4.4.3.2. Starting the Printing
The printing can be initiated in two parallel and independent ways:
• With the START PRINT command selected on the terminal.
• With the PRINT ON/OFF key on the main pad of the external panel. When the
key is pressed, the START PRINT command is executed for the text file that was
printed most recently. The key can be used no matter where the cursor position is
within the control menu (for example, you can start the printing while editing a
subfile).
The printing is started in the following way. In the main MENU select the PRINTING
item and then the START PRINT item.
!