EBS EBS-6100 - SERVICE and maintenance; Routine Maintenance Procedures

EBS
Ink-Jet Systems
®
 EBS-6100 Printer User's Manual
 Paragraph 6 - SERVICE and maintenance
20070529#20.5
 105
6. SERVICE and maintenance
6.1. Routine maintenance
Before starting maintenance operations, read section 2.1 Safety Requirements.
The maintenance provided by the user consists of, among other things, periodical inspections
and service operations to keep the unit in good working order. Some maintenance operations
need to be done every day while others after specified periods of time.
Daily maintenance:
 check for the proper level of ink and solvent in the bottles and prepare new bottles to
replace those about to finish, if necessary;
 after switching the unit on, check for correct adjustments within the head by monitoring
the indications on the terminal according to section 6.2 Checking the adjustments.
Routine maintenance:
 Check periodically (every several switching off operations or preferably every day)
whether the inside of the head is clean and possibly remove ink impurities from the gutter,
nozzle and from the surface of the electrodes with a solvent spray or a gentle brush.
Błąd! Nie można odnaleźć źródła odwołania.
Waste solvent vessel
Spray
Fig. 6.1.1.
 It is recommended that the main ink filter and ink filter inside the gun be changed every
1000 hours of operation (or more frequently, if required) - see section 6.3.5 Occluded
Ink Filter in the Gun.
The entire air filter needs to be replaced at the same time when the main ink filter is
replaced but not less frequently than every 1000 hours of printer operation
(see
Fig. 6.3.6.1). This also applies to the air filter in the electronic chamber (see Fig. 6.3.5.3.).
 Every 2000 hours of operation (or more frequently, if required) check the quality of ink
inside the ink system and possibly change the ink. This is regular practice and the user
should follow it. The operation should be done by a qualified person or serviceman. The
EBS