Eckold KF 170 PD - Connection; Installation; Required Personnel; Pneumatic Connection

29
Kraftformer KF 170 PD
2018-05-09 | ECKOLD AG
6 Connection / Installation
6.1 Required personnel
Well trained and qualified personnel with the following knowledge must be used.
Training for working with the following components:
- mechanical components
Instruction and / or reading of the instruction manual, chapter:
03 Fundamental safety instructions, 06 Connection / Installation
6.2 Pneumatic connection
Unpack the pneumatic foot pedal switch and connect it as shown under (a) and (b).
Connect the air supply as shown under (c) and fasten it securely.
Open the stop cock (1) and check that the required 6 bar of pneumatic pressure are indeed avai-
lable (2).
Pic. 6.2 - Connecting air supply
ø 9 mm
1
2
Connection / Installation