Kraftformer KF 170 PD
2018-05-09 | ECKOLD AG 36
The working stroke can be adjusted between 2 and 6 mm in length by turning the adjusting
knob (1) clockwise or anti-clockwise, this to preselect the pressure applied on the workpiece.
Turning the knob anti-clockwise increases the stroke length. Turning the knob clockwise
shortens the stroke length.
Pull out the locking bolt (2) before attempting to turn the knob.
After adjusting the stroke length the locking bolt should be pushed back in to avoid unintended turning of
the knob.
7.7 Ram stroke limitation
1
2
3.2 + 0.2 = 3.4 Stroke length setting
2 - 6 mm
+/- 0.05 mm
max 6 mm
min. 2 mm
i IMPORTANT
Turn the knob carefully when reaching the upper and the lower position! The knob can be
jammed when it is turned too quick or too strong against the end position.
Pic. 7.7 - Ram stroke limitation
Operation
To Next Page
Loading...