Kraftformer KF 170 PD
2018-05-09 | ECKOLD AG 48
8.4.3.1 Maintenance of standard forming tools
8.4.3 Mechanical components
For the maintenance of the mechanical components Specialist personal with the following
knowledge must be used:
Training for working with the following components:
- mechanical components
Instruction and / or reading of the instruction manual, chapter:
03 Fundamental safety instructions, 05 Construction and Operation, 07 Operation,
08 Maintenance
WARNING
— Personnel does not fulfil the requirements
—> Risk of injury to personnel and damage to the machine
• Only use personnel who fulfil the requirements above.
• Keep the tools free of dust and metal residues.
• Tools may not be oiled or greased.
• If the normal forming power cannot be reached, the tools must be reconditioned.
Pay attention to the tool catalogue during repairs to tools.
• Change the spare parts only per sets to guarantee a perfect functioning of the machine
• Always recondition the entire tool (upper and lower part).
• Do not try to force an achievement of the original forming power by using higher working
pressure. This leads to an overload of the machine and tool.
• For ordering spare parts, please use the tool catalogue.
iIMPORTANT
• In all forming tools rubber-metal combinations are essential construction elements.
These can be damaged by lubricants.
Maintenance
To Next Page
Loading...