Kraftformer KF 170 PD
2018-05-09 | ECKOLD AG 46
8.3.2 Pneumatic components
For the maintenance of the pneumatic components Specialist personal with the following
knowledge must be used:
Training for working with the following components:
- pneumatic components
Instruction and / or reading of the instruction manual, chapter:
03 Fundamental safety instructions, 05 Construction and Operation, 07 Operation,
08 Maintenance
8.3.2.1 Check pneumatic connectors and cables for visible damages
• Check that there is no visible damage to pneumatic connectors and cables.
If there is damage to pneumatic connectors and cables :
• Disconnect the air supply.
• Ensure that operation with the product is not resumed (e.g. using warning signs).
• Get the damage repaired immediately by the maintenance service of your company, or
through the customer service department of the machine manufacturer.
8.3.2.2 Check pneumatic switch- and control elements for visible damages
• Check that there is no visible damage to pneumatic switch- and control elements.
If there is damage to pneumatic switch- and control elements:
• Disconnect the air supply.
• Ensure that operation with the product is not resumed (e.g. using warning signs).
• Get the damage repaired immediately by the maintenance service of your company, or
through the customer service department of the machine manufacturer.
WARNING
— Unintentional starting of the product
—> Risk of injury to personnel and damage to the product
• Always turn the air supply before attempting any repairs or service work.
Maintenance
To Next Page
Loading...