417101774_EMP_KKS_E60_E.doc - 11 - Rev. 8-03.10
6 Mounting
WARNING
The installation must only be performed by authorized personnel and the general guidelines
and local installation regulations must be observed!
- The metering pump should be fitted in an easy-to-access, frost-free location.
The ambient temperature must not exceed +40° C.
- The mounting position of the device must be horizontal.
6.1 Mounting diagram
Pos. Description
1 pressure relief valve
2 metering valve / pressure control valve
3 suction pipe / bottom admission valve
Fig.. 6.1
)
NOTE
The metering valve, pressure control valve and pressure relief valve can be replaced by a
multifunction valve (MFV) from our product range, which combines all of these
functionalities.
To Next Page
Loading...
