417101774_EMP_KKS_E60_E.doc - 43 - Rev. 8-03.10
10.3.12 Configuration / Metering controller“ (only E60
PLUS
& OGM
PLUS
)
If the metering controller is active, in conjunction with the connection of an
OGM
PLUS
for
recording the metering rate, the pump’s metering performance in ‘internal’ and ‘current’
modes can be adjusted within the performance limits. I.e. if it is not possible to reach the set
delivery rate due to external influences, then the metering frequency of the pump is
automatically increased until the desired discharge flow is reached.
If external influences increase the feed rate by too much, the controller reduces the metering
frequency.
)
NOTE
The metering controller function can only be activated if the pump is upgraded with a
dongle box to the E60
PLUS
and oval gear meter , type OGM
PLUS
(see Accessories) is
connected.
To activate the Dongle-Box in connection with the oval gear meter, the power supply has
to be switched off and on again!
10.3.12.1 Selecting
Fig. 10.28
- controller function is inactive.
(Default setting)
9 controller function is active.
To Next Page
Loading...
