417101774_EMP_KKS_E60_E.doc - 33 - Rev. 8-03.10
10.2.2.2 Display in the operating display/ Setting
The metering rate can b
e configured/adjusted in the operating display during operations.
NOTE
If the newly set value is not confirmed within 10 seconds by pressing the START/STOP
key, the system reverts to the primarily value.
Strokes/min
Fig. 10.4
Percent (%)
Fig. 10.5
Liter/min Gallons/day
Fig. 10.6
Fig. 10.7
10.2.3 Operation mode / pulse
For the “pulse” operatio
n mode, the metering pump only works in conjunction with incoming
pulses (e.g. from a contact water meter).
The following pulse processing options can be selected:
•
Multiplication Incoming pulses are multiplied by a configurable factor (n):
1 pulse = n pump strokes (default setting)
• Division Incoming pulses are divided by a configurable factor (n):
n pulse = 1 Pumpenstroke
To Next Page
Loading...
