Ecolab Elados EMP KKS E60 - Batch; Input (Only at E60 WITHOUT Dongle Box)

417101774_EMP_KKS_E60_E.doc - 51 - Rev. 8-03.10
Fig. 10.47
10.3.15.3 Batch / Input (only at E60 WITHOUT Dongle box
)
The “Input” setting is used to determine which input (pulse input or metering lock) at plug II
of the pump should be used to evaluate the start pulse for the batch metering.
The start pulse cable connection depends on the selected input:
Input pulse = plug II Pin 2+4
Input metering lock = plug II Pin 3+4
see chapter 7.2.3.4
and 8.2.2.1.
NOTE
In this case, the original function (e.g. pulse) can no longer be used.
When using a dongle box, a separate input is available.