Ecolab Elados EMP KKS E60 - Replacement of Ceramics Cylinder Unit

417101774_EMP_KKS_E60_E.doc - 62 - Rev. 8-03.10
11.3 Replacement of ceramics cylinder unit with piston
Procedure as described in chapter 11.2.
Pos. Designation
1 Ceramics c
y
linder unit
2 O-Rin
g
, Ø 22 x 2
(
FPM
)
3 O-Rin
g
, Ø 22 x 2
(
EPDM
)
4 S
p
rin
g
5 O-Rin
g
, Ø 14 x 2,5
6 Valve ni
pp
le
7 Washer
8 Valve ball
9 O-Rin
g
, Ø 12 x 1,5
# Unscrew the valve nipple (pos. 6).
# Remove the washer (pos. 7), valve ball (pos. 8) and spring (pos. 4).
# Unscrew the ceramics cylinder unit (pos. 1) in direction of diaphragm seat.
# Insert a new unit. Replace the O-rings (pos. 2, 3, 5, 9)
# Re-install valve nipple (pos. 6), balls (pos. 8) etc.
ATTENTION
The ceramic cylinder may only be exchanged in connection with the ceramic piston.
Fig. 11.4