Ecotech Serinus 44 - Page 158

Serinus 44 User Manual 3.0
Page 158
30
Analog input 5
Cell pressure
31
Analog input 6
Ambient pressure
32
Analog input 7
Raw ADC calibration input
33
Analog input 8
MFC1 Not used
34
Analog input 9
Concentration data
35
Analog input 10
MFC2 Not used
36
Analog input 11
MFC3 Not used
37
Analog input 12
EXTERNAL ANALOG INPUT 0
38
Analog input 13
EXTERNAL ANALOG INPUT 1
39
Analog input 14
EXTERNAL ANALOG INPUT 1
40
Analog input 15
MFC0 Not used
41
CO Meas. Zero Pot (coarse)
S30 Measure ZERO coarse adjustment Pot
42
CO Meas. Zero Pot (fine)
S30 Measure ZERO fine adjustment Pot
43
SO2 Input Pot
SO2 Measure Signal Gain Pot
44
SO2 Ref. Gain Pot
SO2 Reference Signal Gain Pot
45
SO2 Meas. Zero Pot
SO2 Measure zero pot
46
O3 Input Pot
O3 Input signal gain pot
47
Diagnostic Test Pot
The Diagnostic mode adjustment pot for all the
instrument except for S30
48
NOx Input Pot
PMT signal input gain control FOR NOX
49
PGA Gain
1, 2, 4, 8, 16, 32, 64, 128
50
Gas 1 Conc.
Primary gas concentration currently displayed on the
front screen E.g. NO
51
Gas 2 Conc.
Secondary gas concentration currently displayed on
front screen E.g. NOx
52
Gas 3 Conc.
Calculated gas concentration currently displayed on
front screen E.g. NO2
53
Gas 1 Avg.
Average of the readings (for Gas1) of the last n minutes
where n is the averaging period
54
Gas 2 Avg.
Average of the readings (for Gas2) of the last n minutes
where n is the averaging period
55
Gas 3 Avg.
Average of the readings (for Gas3) of the last n minutes
where n is the averaging period
56
Instrument Gain
Current calibration value (default is 1.0)
57
Serial ID
Multidrop or Bayern-Hessen gas id
58
Bayern-Hessen 2nd ID
For multigas instruments only
59
Decimal Places
2-5
60
Noise
Instrument noise