6
II. Quick Setup
Your access point can be up and running in just a few minutes. It can function
as a standalone access point (AP mode), as part of an AP array (Managed AP
mode) or as a wireless repeater (repeater mode).
For use a Managed AP in an AP array, the access point will automatically
switch mode when an AP Controller is configured as described in Edimax Pro
NMS.
II-1. Initial Setup
1. Connect the access point to a computer via Ethernet cable.
2. Connect the power adapter to the access point’s 12V DC port and plug the
power adapter into a power supply using the included cable.
3. Please wait a moment for the access point to start up. The access point is
ready when the LED is blue.
4. Set your computer’s IP address to 192.168.2.x where x is a number in the
range 3 – 100. If you are unsure how to do this, please refer to the user
manual for more information.
Please ensure there are no other active network connections on
your computer (disconnect Wi-Fi connections and Ethernet
cables).
To Next Page
Loading...
Need help?
General
