62
IV-3-5. WPS
Wi-Fi Protected Setup is a simple way to
establish connections between WPS
compatible devices. WPS can be activated on compatible devices by pushing a
WPS button on the device or from within the device’s firmware/configuration
interface (known as PBC or “Push Button Configuration”). When WPS is
activated in the correct manner and at the correct time for two compatible
devices, they will automatically connect. “PIN code WPS” is a variation of PBC
which includes the additional use of a PIN code between the two devices for
verification.
Please refer to manufacturer’s instructions for your other WPS
device.
To Next Page
Loading...
Need help?
General
