Edimax CAP1750 User Manual

46
802.11g Protection
Enable/disable 802.11g protection, which
increases reliability but reduces bandwidth
(clients will send Request to Send (RTS) to
access point, and access point will broadcast
Clear to Send (CTS), before a packet is sent
from client.)
802.11n Protection
Enable/disable 802.11n protection, which
increases reliability but reduces bandwidth
(clients will send Request to Send (RTS) to
access point, and access point will broadcast
Clear to Send (CTS), before a packet is sent
from client.)
DTIM Period
Set the DTIM (delivery traffic indication
message) period value of the wireless radio.
The default value is 1.
RTS Threshold
Set the RTS threshold of the wireless radio. The
default value is 2347.
Fragment
Threshold
Set the fragment threshold of the wireless
radio. The default value is 2346.
Multicast Rate
Set the transfer rate for multicast packets or
use the “Auto” setting.
Tx Power
Set the power output of the wireless radio. You
may not require 100% output power. Setting a
lower power output can enhance security since
potentially malicious/unknown users in distant
areas will not be able to access your signal.
Beacon Interval
Set the beacon interval of the wireless radio.
The default value is 100.
Station idle
timeout
Set the interval for keepalive messages from
the access point to a wireless client to verify if
the station is still alive/active.

Edimax CAP1750 Specifications

General

Brand	Edimax
Model	CAP1750
Category	Wireless Access Point
Language	English