57
Set the fragment threshold of the wireless
radio. The default value is 2346.
Set the transfer rate for multicast packets or
use the “Auto” setting.
Set the power output of the wireless radio. You
may not require 100% output power. Setting a
lower power output can enhance security since
potentially malicious/unknown users in distant
areas will not be able to access your signal.
Set the beacon interval of the wireless radio.
The default value is 100.
Set the interval for keepalive messages from
the access point to a wireless client to verify if
the station is still alive/active.
To Next Page
Loading...
Need help?
General
