14 Installation and Service Guide: Printer Controller EB-34
Installing Hardware
4 Do the following to prepare the copier for use with the EB-34:
• Install the Gigabit Ethernet board in the copier.
• Install the Fiery key top on the copier.
• Enter SP mode on the copier and specify the correct SP setting to enable communication between the copier and
the EB-34.
The following SP settings are needed for the EB-34:
• SP5193-001:[1]
• SP5895-001:[1]
• SP5895-002:[0]
• SP5985-001:[1]
• SP4-201-011[1]
• SP4-201-012[1]
• Apply the Fiery decal the copier.
5 Connect the following cables:
• Power cable (see page 17)
• Copier interface cable (crossover Ethernet cable) from the lower Ethernet port (see page 17)
• Network cable (straight-through Ethernet cable) from the upper Ethernet port (see page 19)
6 Complete the installation (see page 20).
Remind site administrator to install current user software on client computers that print to the EB-34 (see Printing
and Utilities, which are part of the user documentation set).
Checking the customer site
Before you install the EB-34, check site conditions and inform the customer of any installation requirements.
To check the customer site
• Is the copier configured for use with the EB-34?
For correct settings, see the documentation that accompanies the copier.
Important: For more information about installing the Gigabit Ethernet board and the Fiery key on the copier,
and changing the SP mode of the copier, see the Service Manual for the copier. This information is not found
in the documentation for the EB-34.
To Next Page
Loading...
Need help?
General
